The iW671 replaces the secondary-side Schottky diode used in conventional power supplies with a more efficient MOSFET and works with Dialog’s iW1786 or iW1787 primary-side controllers to deliver efficiency greater than 88%. This enables the higher power density needed for more powerful, small form-factor adapters without exceeding thermal limits.

Conventional power supplies use Schottky diodes to rectify the output voltage (change the AC voltage to a DC voltage). When replacing the Schottky diode with a synchronous rectifier, the voltage dropped across the switching MOSFET is less than the forward voltage of the Schottky diode, thereby reducing power loss.

However, conventional synchronous rectifiers still require a Schottky diode to be used in parallel as they need to turn off when approaching the zero crossing to eliminate the risk of shoot-through, which can overheat and potentially destroy the power supply.

The iW671 uses Dialog’s proprietary digital control technology to eliminate the need for the parallel Schottky diode. Synchronous rectification also leads to an efficiency improvement of approximately 4% at 5V, resulting in the high >88% full-load efficiency for higher power operation in a small form-factor without overheating the power supply.

The iW671 is designed to work for 15W or 50W output power, ultra-low no-load standby power consumption of <15mW (iW1786) and <30mW (iW1787) and high efficiency, enabling chargers and adapters to meet stringent global energy standards including the final 2014 U.S. DOE and European CoC version 5, tier 2 regulations.

Power supplies for electronic products continue to consume power when plugged in but not in use. To achieve low standby power, these power supplies typically enter a low standby operating mode. However, when a load is applied, they need to “wake up” quickly to keep the output voltage from dropping too low. Dynamic load response (DLR) is determined by the speed at which the system wakes up and responds to changes in the power load.

Typical adapter and charger design approaches achieve low standby power and high efficiency at the expense of slow wake up (i.e. slow DLR performance). The iW671 enables ultra-fast DLR for quicker recovery from low-power standby mode by integrating an adaptive voltage position monitor that detects the flyback converter output voltage undershoot.

“With global energy regulations for power consumption becoming more and more stringent, power supplies are being pushed to their cost, performance and size limits,” said Davin Lee, Senior Vice President and General Manager of the Power Conversion Business Group at Dialog Semiconductor.

“Dialog’s innovative iW671 synchronous rectifier and controller solutions will now provide designers with the ultimate combination of higher efficiency, faster standby recovery performance and a reduced BOM for a new generation of low cost adapters and chargers.”

Features:

－ iW1786+iW671: up to 15W output power, <15mW no-load standby power consumption

－ iW1787+iW671: up to 50W output power, <30mW no-load standby power consumption

－ Eliminates parallel Schottky diode

－ Higher efficiency >88% (full load)

－ Fast dynamic load response

－ Complies with US DOE(1) and EU CoC V5, Tier 2(2) requirements for external power supply efficiency